What should you do while leaving a dock if the wind or current pushes you back onto it quizlet?

If the wind or current is pushing your boat toward the dock you will have to do some extra planning.

1. Cast off all lines except an after bow spring line. This line will keep you from moving forward and allow the stern to pivot away from the dock. (see illustration) 2. You may want to use a fender forward to cushion the bow of the boat against the dock. 3. Turn the motor or rudder to the direction necessary to push the stern away from the dock. 4. Shift into forward at idle speed. Slowly, very slowly. 5. The stern will swing away from the dock. When it is clear of all obstacles and traffic, cast off the spring line and back away from the dock.

6. When you are safely away, shift to forward and idle away from the dock.

Animation

Once you are clear of the dock, stow lines and fenders so they will not be in the way or pose a tripping hazard. Be sure to control speed when leaving the dock and check for other boats, swimmers or other obstacles.

Docking Plan

Before approaching the dock, one end of the docking lines should be secured onboard; fenders readied and speed reduced.

If the wind is onshore (blowing toward the dock), the boat is brought to a position parallel to the dock and about two feet off. The wind will blow the boat in. It can then be secured by bow, stern and spring lines.

If the wind is offshore (blowing away from the dock), you should approach the dock at a 20 to 30 degree angle. A bow line is passed ashore and secured. In boats with an outboard, or inboard/outboard engine, the engine is turned towards the dock and put in reverse. This will bring the stern into the dock. The boat can then be secured with the stern line.

The procedure is different for boats with inboard engines. The rudder will be used to bring the stern in. To push the stern in using the rudder, attach an after bow spring to keep the boat from moving forward. With the engine idling forward, turn the wheel away from the dock as illustrated below. Since the boat cannot move forward and the rudder is pushing the stern in, the boat will pin itself against the dock while you secure the other lines. All maneuvers are more easily accomplished if the boat has twin engines, rather than a single engine.

Animation

For additional information on docking check out Docking Tips Continued . . ..

Provided By:
Boatsafe.com

Docking With Wind or Current Toward the Dock

1. Approach slowly, parallel to the dock.
2. Let the wind or current carry your boat to the dock. Shift into gear briefly if you need to adjust position.
3. Secure the bow and stern lines.

What is the best way to approach a dock when there is strong wind or current with the wind or current ?, Answer Expert Verified. the best way to approach a dock when there is strong wind or current is we should approach the dock at a 20-30 degree angle. By doing this, we could secure a bow line, put the engine in reverse toward the dockand bring stern into the dock.

Furthermore, How should you approach a dock when the wind ?, Docking With Wind or Current Away From the Dock

1. Approach the dock slowly at a sharp angle (about 40 degrees).
2. Use reverse to stop when close to the dock. Secure the bow line.
3. Put the boat in forward gear briefly, and slowly turn the steering wheel hard away from the dock — this will swing in the stern. Secure the stern line.

Finally, How do you dock a boat with wind and current ?, At Your Back. If the wind is at your back, you should approach the dock at a shallow angle (10 ° -20 °), and then stop the boat in order to allow the wind to drift the boat into the dock. If possible, approach the dock with the wind into your face: you have much more control when docking into the wind.

Frequently Asked Question:

Wind or current is pushing your boat away from the dock

See also  How to make the chimney not smoke?

When clear and safely away from the dock and other boats, shift to forward and depart at idle speed. Be careful to make sure you have been pushed safely away and that the stern will not hit the dock as you motor forward and turn.

Approach slowly, parallel to the dock. Let the wind or current carry your boat to the dock.

Casting Off With Wind or Current Away From the Dock

1. Cast off the bow and stern lines.
2. Use an oar or boat hook to keep the boat clear of the dock. Let the wind or current carry the boat away from the dock.
3. Once there is sufficient clearance, shift into forward gear and slowly leave the area.

At least one anchor set up and bent-on to your anchor line. Two or three extra docklines in case of unusual dockside conditions. Visually inspect the lines you use for chafe or wear. At least two fenders on-board for docking or towing if required.

If the wind is at your back, you should approach the dock at a shallow angle (10 ° -20 °), and then stop the boat in order to allow the wind to drift the boat into the dock. If possible, approach the dock with the wind into your face: you have much more control when docking into the wind.

Docking With Wind or Current Away From the Dock

1. Approach the dock slowly at a sharp angle (about 40 degrees).
2. Use reverse to stop when close to the dock. Secure the bow line.
3. Put the boat in forward gear briefly, and slowly turn the steering wheel hard away from the dock — this will swing in the stern. Secure the stern line.

Docking With Wind or Current Toward the Dock

1. Approach slowly, parallel to the dock.
2. Let the wind or current carry your boat to the dock. Shift into gear briefly if you need to adjust position.
3. Secure the bow and stern lines.

If the wind is at your back, you should approach the dock at a shallow angle (10 ° -20 °), and then stop the boat in order to allow the wind to drift the boat into the dock. If possible, approach the dock with the wind into your face: you have much more control when docking into the wind.

Approach slowly, parallel to the dock. Let the wind or current carry your boat to the dock. Shift into gear briefly if you need to adjust position. Secure the bow and stern lines.

Answer Expert Verified. the best way to approach a dock when there is strong wind or current is we should approach the dock at a 20-30 degree angle. By doing this, we could secure a bow line, put the engine in reverse toward the dockand bring stern into the dock.

See also  How to help a 6 year old to read and write?

If the wind is in your face, you should approach the dock at a steep angle (30 ° -45 °) and swing the boat quickly. Secure the bow first, then reverse until the stern swings in.

Answer Expert Verified. the best way to approach a dock when there is strong wind or current is we should approach the dock at a 20-30 degree angle. By doing this, we could secure a bow line, put the engine in reverse toward the dockand bring stern into the dock.

Docking With Wind or Current Away From the Dock

1. Approach the dock slowly at a sharp angle (about 40 degrees).
2. Use reverse to stop when close to the dock. Secure the bow line.
3. Put the boat in forward gear briefly, and slowly turn the steering wheel hard away from the dock — this will swing in the stern. Secure the stern line.

At Your Back. If the wind is at your back, you should approach the dock at a shallow angle (10 ° -20 °), and then stop the boat in order to allow the wind to drift the boat into the dock. If possible, approach the dock with the wind into your face: you have much more control when docking into the wind.

If the wind is offshore (blowing away from the dock), you should approach the dock at a 20 to 30 degree angle. A bow line is passed ashore and secured. In boats with an outboard, or inboard / outboard engine, the engine is turned towards the dock and put in reverse.

Docking With Wind or Current Toward the Dock

1. Approach slowly, parallel to the dock.
2. Let the wind or current carry your boat to the dock. Shift into gear briefly if you need to adjust position.
3. Secure the bow and stern lines.

Answer Expert Verified. the best way to approach a dock when there is strong wind or current is we should approach the dock at a 20-30 degree angle. By doing this, we could secure a bow line, put the engine in reverse toward the dockand bring stern into the dock.

(Visited 9 times, 1 visits today)